产品中心
新闻动态 当前位置:首页>新闻动态>新闻动态

清洗大量NSK轴承时

网址:www.nsk-zc.cn  2021-05-20  作者:admin    阅读:

清洗大量NSK轴承时,先用温度为90~100 ℃的热机油淋烫以使封装油熔化,同时用无缝口且不落屑的工具挖净全部旧油,再淋烫几分钟,然后用煤油冲洗去机油,最后再用汽油清洗一遍。清洗洁净后,应戴上薄膜手套将NSK轴承放在工作台上的洁净的布上或纸上晾干。
When cleaning a large number of NSK Bearings, first use hot engine oil with the temperature of 90-100 ℃ to melt the sealing oil. At thetuijian:jianchaj.89ix.com hulan.37ix.com.cn zhuce.71ix.com www.hupomuju.cn
uxingmoju.89ix.com www.liushuicao.cn paishuigou.37ix.com.cn www.moju58.com same time, use seamless and no chip tools to dig up all the old oil. Then use hot oil for a few minutes. Then wash the engine oil with kerosene. Finally, use gasoline to clean it. After cleaning, put on film gloves and dry the NSK bearing on clean cloth or paper on the workbench.
(2)在NSK轴承安装之前,应该用适当的测量工具按设计图纸上的技术要求规定,检查轴和座孔以及有关零件的加工质量,如尺寸精度、形状精度和表面粗糙度等。
(2) Before the installation of NSK bearing, the machining quality of shaft, seat hole and relevant parts, such as dimensional accuracy, shape accuracy and surface roughness, should be checked with appropriate measuring tools according to the technical requirements on the design drawings.
(3)临安装时打开NSK轴承封装,将它浸入上述汽油等液体中以手轻缓地转动,要保证保持架,滚动体以及滚道表面的封装油彻底被清洗洁净。
(3) Before installation, open the NSK bearing package, immerse it in the above-mentioned gasoline and other liquid, and turn it gently by hand. Ensure that the seal oil on the cage, rolling element and raceway surface is thoroughly cleaned.
(4)应将装配表面用洁净的汽油、煤油、甲苯或二甲苯等溶液清洗洁净,并用洁净的抹布擦干,再涂上薄薄一层润滑油,这样可使安装操作更方便。
(4) The assembly surface shall be cleaned with clean gasoline, kerosene, toluene or xylene solution, dried with clean cloth, and then coated with a thin layer of lubricating oil, so as to make the installation and operation more convenient.
(5)注意带密封NSK轴承不可用本法清洗,密封的内部应保持原样不可清洗。
(5) Note that the NSK bearing with seal can not be cleaned by this method, and the inside of the seal should be kept as it is.

返回新闻

转让电话
13313028229